A b d, Figure 7 front windpipes – Hired-Hand RollSeal Rollup Curtains: ROLLUP CURTAIN SYSTEM Rev 12-07 User Manual
Page 16
Part No. 4801-5169 Rev 12-07
Rollup Curtain System
Page 16
6.8 Front Windpipes
Now install windpipes to front of system. NOTE: Curtain not shown in diagrams below for clarity.
1.
Place pipe in groves in brackets (A).
2.
Slide windpipe upward until opposite end of windpipe is above bottom bracket (B). If installing a
double stack system, make sure that wind pipe aligns with slot of middle bracket.
3.
Insert end of wind pipe through corresponding hole of bottom bracket (C)
4.
Install clamp to middle bracket with #14-1 Tek screws to secure windpipe in place (D). Install
screws through top and bottom brackets to secure windpipe (D).
5.
Repeat steps A-D to install windpipes to all front brackets of system.
A B
D
Figure 7
Front Windpipes
NOTE: Single System installs by the same procedures
except there is no middle stringer.
C