Rollup drive – drive pipe installation, Figure 9 - drive pipe installation, Detail a detail b – Hired-Hand RollSeal Rollup Curtains: ROLLUP CURTAIN SYSTEM Rev 12-07 User Manual
Page 18: Detail c drive pipe cabinet
Part No. 4801-5169 Rev 12-07
Rollup Curtain System
Page 18
8. Rollup Drive – Drive Pipe Installation
1. Move the Motor all the way to the bottom limit of the Rack. See Figure 9.
2. Attach the Universal Joint to the Motor Drive Shaft. See Figure 9, Detail A.
2. To attach the Drive Pipe, drill a 3/8" diameter hole 13/16 inches from the end of the drive pipe. See Figure 9,
Detail B.
3. Attach the drive to the universal joint assembly as shown in Figure 9.
4. Attach the Rollup Drive to the Curtain Pipe using Universal Joints (6419-0204) as shown in Detail A. The End
of the Drive Pipe must be 12 inches from the edge of the Cabinet. See Detail C.
5. Fasten the drive pipe, coupling and universal joint with an M-10 bolt and nut.
M-10 bolt
Detail A
Detail B
Flexible
shaft
Cabinet
Drive
Pipe
Universal
Joint
13/16"
Figure 9 - Drive Pipe Installation
Coupling
Nut
7/16 " dia. hole
Detail C
Drive Pipe
Cabinet
12" "
Universal Joint
Flexible
shaft
Motor
Shaft