Curtain installation using windpipe brackets, Figure 1 bottom bracket – Hired-Hand RollSeal Rollup Curtains: ROLLUP CURTAIN SYSTEM Rev 12-07 User Manual
Page 9
Part No. 4801-5169 Rev 12-07
Rollup Curtain System
Page 9
Install brackets 10 ft. (304.8 cm)
O.C. along the bottom stringer.
6. Curtain Installation Using Windpipe Brackets
6.1 Bottom Windpipe Brackets
Windpipe brackets are supports for wind pipes.
1.
Install first windpipe bracket on bottom stringer 10 feet away from cabinet. Fasten bracket securely with
screws provided.
2.
Over the entire length of the system, install windpipe brackets along the bottom stringer. Install windpipe
brackets 10 ft. (304.8 cm) O. C. (on center).
Determine where your curtain will start.
Install first bottom bracket at this point.
Figure 1
Bottom Bracket
10 ft. (304.8cm)
Center-to-center
Bracket
NOTE: If post is
encountered, shift
bracket to the short
side of the post
Post
10 'from edge
of cabinet
NOTE: If securing to
a concrete knee-wall,
use the provided tap-
con anchors.