Installation, Caution, A-11 – Lincoln Electric IM915 POWER FEED 10M SINGLE WIRE FEEDER User Manual

Page 19

Advertising
background image

INSTALLATION

POWER FEED

®

10M SINGLE WIRE FEEDER

A-11

A-11

Using K1504-1 Coil Reel
50-60 lb. (22.7 - 27.2 kg) Coil Mounting
(See Figure A.10)

1. Make sure the spindle of the wire reel stand is in

the upper position.

2. With the coil reel assembly mounted to a 2" (51mm)

spindle, loosen the spinner nut and remove the
cover plate. Alternatively, lay the coil reel assembly
flat on the floor and loosen the spinner nut and
remove the cover plate.

3. Place the coil of electrode on the reel so it unwinds

from the bottom as it rotates.

4. Tighten the spinner nut as much as possible by

hand using the cover plate spokes for leverage.
DO NOT hammer on the spinner nut.

5. Cut and remove only the tie wire holding the free

end of the coil. Hook the free end around the rim of
the cover plate and secure it by wrapping it around.
Cut and remove remaining tie wires.

• Always be sure the free end of the coil is secure-

ly held while the tie wires are being cut and until
the wire is feeding through the drive rolls.
Failure to do this will result in "backlashing" of
the coil, which may tangle the wire. A tangled
coil will not feed and must either be untangled or
discarded.

------------------------------------------------------------------------

6. Be sure the coil is engaged with the spindle brake

pin and the release bar on the retaining collar "pops
up". The retaining collar must fully engage the
retaining groove on the spindle.

CAUTION

SPINNER
NUT

CARDBOARD
LINER

COVER
PLATE

TIE
WIRE

SPRING
ARM

REEL

COIL

SLOTS

FIGURE A.10

Advertising