Lincoln Electric IM915 POWER FEED 10M SINGLE WIRE FEEDER - Manual (Page 22)

A-14 INSTALLATION
POWER FEED ® 10M SINGLE WIRE FEEDER
A-14
Hard Automation System
Shown with
• K2657-1 Control Box
• K1780-2 PF-10/R
• K2203-1 Power Wave
® 455M/STT
• K2205-1 Wire Drive Module
Multiple Wire Feeder System
• Load one feeder with solid wire, the other with flux
cored.
• Great for pipeline work.
Shown with
• K2429-1 ArcLink T Cable Connector
• K2536-1
• K2536-1 Power Feed
® 25M
• K2203-1 Power Wave ® 455M/STT
ArcLink Systems
Many other ArcLink systems may be assembled
besides those shown in this manual. The majority will
self configure. If an assembled system flashes the sta-
tus light green rapidly on all components, contact the
Lincoln Electric Company for further assistance.
Current Power Feed ® 10M models that will not self
configure...
• K2316-1 Power Feed 10M Dual Boom
These configurations will require Dip Switches to be
set. See the power source instruction manual on how
to disable self configuration.
EXAMPLES OF CONNECTING AN
ARCLINK POWER WAVE SYSTEM
ArcLink Power Wave ® products may be configured in
many different ways. The flexible system allows multi-
ple wire feeders to be connected to the same power
source. The diagrams represent some of the common
methods for connecting ArcLink Products.
Important: Bench model wire feeders cannot be sepa-
rated into a separate control box and wire drive for a
boom system.
Common ArcLink Systems
The following Power Wave
® systems may all be
assembled without any changes to the equipment DIP
switches
Basic Semi-Automatic System
• Great for general fabrication.
Shown with
• K2230-2 POWER FEED ® 10M Single Wire Feeder
• K2203-1 Power Wave ® 455M/STT
Robotic/Semi-Automatic System
• Use the bench feeder for offline welding.
Shown with
• K2230-2 POWER FEED ® 10M Single Wire Feeder
• K1780-2 PF-10/R
• K2203-1 Power Wave
® 455M/STT
• K2205-1 Wire Drive Module