Star Water Systems 2STHAL (Flint & Walling) - Manual (Page 2)

2
© 2011. All rights reserved .
NOTE: Ratings based on 1-1/4" pipe with friction loss neglected.
Using 3/4" garden hose adapter, performance will be reduced
approximately 15%. This pump does not deliver enough pressure to
operate lawn sprinklers properly.
OPERATION
1. Set pump on hard surface in water before starting.
2. Use the included garden hose adapater for 3/4" discharge line
or disconnect the adapter to use a 1" discharge for 1/6 HP or a
1-1/4" discharge for 1/4 HP.
3. Plug power cord into properly grounded 115 volt AC power
outlet. (See recommended grounding methods on front page).
Will operate continuously whether partly or fully submerged.
Submersible utility pumps are intended to pump clean or dirty
water or water-like liquids at temperatures up to 104˚ F.
4. The pump is supplied with a 3/4" garden hose adpater. For use
with plastic pipe, remove the adapter and install the desired
1" or 1-1/4" NPT fitting. DO NOT OVERTIGHTEN THE HOSE
OR PLASTIC ADAPTER FITTING. Finger tight plus 1/2 turn is
sufficient.
NOTE: These pumps are manufactured with an air vent hole
near the base of the pump to prevent the pump from air-locking.
Air-locking will prevent the pump from pumping water. A stream
of water will be visible from this hole while the pump is running
and pumping water. The hole should be checked and cleaned
as needed.
Do not set pump directly on sand, dirt or mud.
Sand or mud-choked pumps can be back-
flushed clean.
Do not handle or carry the pump by the power
cord. Use the handle.
Extended usage of the pump in a partially
submerged or non-submerged situation may
cause the pump to overheat due to lack of heat dissipation from
the water. If this occurs, the pump will shut itself off until the motor
cools to its normal temperature. Repeated overheating may cause
damage to the pump.
MAINTENANCE
1. The motor housing of the pump is completely sealed and requires
no service. Disassembly of the motor housing or alteration of the
power cord voids all warranty.
2. The motor is a continuous duty type with an automatic thermal
overload protector device.
3. The pump can run against a partially restricted discharge.
4. If the pump becomes clogged, remove the screen and clean out
the area.
5. If necessary, remove the eight (8) screws holding the volute base
to the motor housing and clean the volute.
REPAIR PARTS
Repair Parts Listing
Description
Part Number
1/6 HP Model 1/4 HP Model
Impeller 120334 020328
Adapter 020348 022467
Coupling N/A 020331
Base 021338 020329
Screen 139492 139492
Mechanical Float
Switch
KH30* -
*Optional
This product is warranted for one year from the date of purchase or two years from
the date of manufacture, whichever occurs first. Subject to the conditions hereinafter
set forth, the manufacturer will repair or replace to the original consumer, any portion
of the product which proves defective due to defective materials or workmanship. To
obtain warranty service, contact the dealer from whom the product was purchased.
The manufacturer retains the sole right and option to determine whether to repair or
replace defective equipment, parts or components. Damage due to conditions beyond
the control of the manufacturer is not covered by this warranty.
THIS WARRANTY WILL NOT APPLY: (a) To defects or malfunctions resulting from
failure to properly install, operate or maintain the unit in accordance with printed
instructions provided; (b) to failures resulting from abuse, accident or negligence or
use of inappropriate chemicals or additives in the water; (c) to normal maintenance
services and the parts used in connection with such service; (d) to units which are not
installed in accordance with normal applicable local codes, ordinances and good trade
practices; and (e) the unit is used for purposes other than for what it was designed and
manufactured.
RETURN OF WARRANTED COMPONENTS: Any item to be repaired or replaced
under this warranty must be returned to the manufacturer at Kendallville, Indiana or
such other place as the manufacturer may designate, freight prepaid.
LIMITED WARRANTY
THE WARRANTY PROVIDED HEREIN IS IN LIEU OF ALL OTHER EXPRESS
WARRANTIES, AND MAY NOT BE EXTENDED OR MODIFIED BY ANYONE. ANY
IMPLIED WARRANTIES SHALL BE LIMITED TO THE PERIOD OF THE LIMITED
WARRANTY AND THEREAFTER ALL SUCH IMPLIED WARRANTIES ARE
DISCLAIMED AND EXCLUDED. THE MANUFACTURER SHALL NOT, UNDER
ANY CIRCUMSTANCES, BE LIABLE FOR INCIDENTAL, CONSEQUENTIAL OR
SPECIAL DAMAGES, SUCH AS, BUT NOT LIMITED TO DAMAGE TO, OR LOSS
OF, OTHER PROPERTY OR EQUIPMENT, LOSS OF PROFITS, INCONVENIENCE
, OR OTHER INCIDENTAL OR CONSEQUENTIAL DAMAGES OF ANY TYPE OR
NATURE. THE LIABILITY OF THE MANUFACTURER SHALL NOT EXCEED THE
PRICE OF THE PRODUCT UPON WHICH SUCH LIABILITY IS BASED.
This warranty gives you specific legal rights, and you may have other rights which
vary from state to state. Some states do not allow limitations on duration of implied
warranties or exclusion of incidental or consequential damages, so the above limitations
may not apply to you.
WARRANTY VALID IN CANADA AND MEXICO.