Star Water Systems S1104 - Manual (Page 4)

4
© Copyright 2004. All rights reserved.
OVERLAP DETAIL
GASKET SEAT
FOAM GASKET
GASKET SEAT DETAIL
FOAM GASKET
APPROXIMATELY 1/4" OVERLAP
BASIN
WEEP HOLE DISCHARGE PIPE
DRILL 3/16"
THRU HOLE
6"
2 1/4"
CAP
DRILL
DISCHARGE PIPE
CAP
STEP 3 Installation of the Foam Gasket
3.1) Install the foam gasket into the “gasket seat” at the top of the basin, refer to Figure 3.1 for details.
Figure 3.1
STEP 2A Installation of the Float Assembly
2A.1) Install the fl oat as shown in Figure 2A.1 and Figure 2A.2.
SK2009
Figure 2A.1
SK2003
FLOAT MUST BE
TETHERED IN THE ORIENTATION SHOWN
IN FIGURE 2A.2.
Water stream will be visible from this hole
during pump run periods.
Figure 2A.2
IMPORTANT!