Star Water Systems S1104 - Manual (Page 5)

5
© Copyright 2004. All rights reserved.
INLET
TAIL PIPE
TRAP
FLANGED TAIL PIPE
(SEE NOTE)
CORD SEAL OPENING
DISCHARGE
VENT
X
4 1/2"
TRAP DISCHARGE PARTIALLY
VISIBLE THROUGH THE CORD
SEAL OPENING.
4"
TRAP DETAIL
TAIL PIPE
TAILPIPE
LENGTH
DIMENSION MEASURED
IN STEP 1.
STEP 4 Internal Trap Installation Only
4.1) Cut the tailpipe to the dimension determined in Figure 4.1.
4.2) Install the sink drain components to the lid as shown in Figure 4.2.
4.3) Orient the lid assembly as shown in Figure 4.3 and secure the trap components.
(HAND TIGHTEN the assembly to the lid at this time. Adjustment will be required in Step 5.)
Note: To insure a proper water seal, the extension must be installed as shown in the “trap detail”.
INTERNAL TRAP COMPONENTS SUPPLIED BY OTHERS.
Figure 4.1
Figure 4.2
Figure 4.3
SK2004