Triton RL5000 X2 Series User Manual - Manual (Page 35)

31
G ENERAL M AINTENANCE
4. Pull the pin located on the right side of the printer bracket shown. Rotate the printer/cutter assembly
towards the front of the control panel.
5. Release (O
PEN
) the blue tension lever located on the left side. Remove any paper from the printer/
cutter assembly. Move the tension lever back to the CLOSED position (blue lever facing towards the
right). Close the printer/cutter assembly by rotating up and pin secures.
Open
Closed
Pull release pin. Rotate printer/cutter assembly down.
Tension lever.
Release pin
** CAUTION **
DO NOT pull receipt paper backwards through the
printer with the tension rollers closed!
This may leave paper fragments that can cause pa-
per jams.