Triton RL5000 X2 Series User Manual - Manual (Page 36)

32
M
ODEL
RL5000 (X2) S
ERIES
U
SER
M
ANUAL
Feed paper into the
printer take-up slot.
8. Feed the end of the paper into the printer take-up slot. Note: Paper feeds Over the bar. The printer will
activate and automatically feed the paper through the printer and slightly out the front of the control
panel.
6. Install the new paper roll on the spindle. Unwind enough paper to ensure the glued end that secured
the paper roll is removed.
Note: The spindle is inserted so that the
paper will feed from the TOP of the roll when
it is installed on the paper bracket.
7. Place the paper roll (w/spindle) on the paper
support bracket by sliding ends of spindle on
to the bracket.
Paper roll installed in bracket.
Paper feeds automatically out
front of unit.
Receipt paper installed
* NOTE *
Triton recommends the use of 20# thermal
printer paper (Triton P/N 05403-00053). This
receipt paper has been shown to improve
performance and reliability.
9. If the printer does not feed automatically, open the printer/cutter assembly and check the blue tension
lever for the correct (Closed) position.
10. Close and lock the control panel. Go to M ANAGEMENT F UNCTIONS > D IAGNOSTICS and perform a R ESET /
T
EST
P
RINTER
.