Triton 97XX Series Operation Manual - Manual (Page 177)

TRITON SYSTEMS, INC.
SECTION 5 - MANAGEMENT FUNCTIONS O
PERATION
M
ANUAL
- M
ODEL
97XX-Series
5-122
9700-S ERIES 9705-S ERIES 9710-S ERIES 9750-S ERIES
RESET/TEST MODEM
F ACTORY D EFAULT : N/A
A CCESS I NSTRUCTIONS :
1. Select TERMINAL CONFIGURATION from the MANAGEMENT
FUNCTIONS menu.
2. Select SET TERMINAL PARAMETERS.
3. Select TELEPHONE.
4. Select the MODEM SETUP option.
5. Select RESET/TEST MODEM.
D
ESCRIPTION
:
This function is used to reset and test the internal modem. It should
be run after setting any of the modem configuration parameters to
make sure an error was not made. It MUST be run after changing
the DIAL MODE or DIAL RATE, otherwise these new values will
not take effect until the unit is turned off and back on again.
At the conclusion of the test a screen will appear indicating that the
MODEM CONFIGURED AND TESTED OK.
E RROR C ONDITIONS :
An error message will indicate a problem if the setup string is in-
valid or the modem is not responding.