Triton 97XX Series Operation Manual - Manual (Page 216)

TRITON SYSTEMS, INC. 6-3
SECTION 6 - MAINTENANCE O
PERATION
M
ANUAL
- M
ODEL
97XX-Series
2. If paper remains on the roll, cut the paper between the roll and
the printer with a pair of scissors, as shown in Figure 1.
3. Use the RECEIPT PRINTER PAPER FEED BUTTON (Figure
6-2) to feed the paper through the paper path until all paper
comes out the front of the printer.
4. Push the paper spool (or partial roll of paper) from its location
in Figure 6-3A to the position shown in Figure 6-3B.
5. Remove the paper spool from the paper support bracket by
pulling the slotted small end of the spool out of bracket.
5. Remove the tab securing the end of the new paper roll to itself.
Use scissors to cut off all of the paper up to and including the
glue tab. Insert the paper spool into the new roll of paper (as
shown in Figures 6-4A and 6-4B). Use a 6-inch roll of 60-mm
wide thermal paper. Be sure the paper spool is inserted so that
the paper will feed from the top of the roll when it is installed on
the paper bracket.
6. Place the paper roll and paper spool back on the paper bracket
by sliding the small slotted end of the spool into the large hole
in the bracket as shown in Figure 6-5A. Note that the paper
feeds from the bottom of the roll. Push the paper and spool
into the operating position to lock them in place as seen in
Figure 6-5B.
7. Once the paper roll and spool are installed on the paper bracket,
take the end of paper roll and feed it into the printer path paper
entrance, as shown in Figure 6-6. Note that the paper feeds
from the bottom of the roll.
8. Once the paper is fed into the paper path entrance, the printer
will activate and automatically feed the paper through the printer
and out the exit. See Figure 6-7.
9. Close and lock the Cash Dispenser.
Figure 6-3B The Paper Spool in
position for removal.
Figure 6-4A. The paper and paper
spool.
Figure 6-4B. Spool inserted into the
roll of paper.
Figure 6-5A. Placing the paper roll
and spool on the paper bracket.
WARNING
Do not pull the paper backward through the printer.
This may leave paper fragments that can cause paper
jams.