Work Sharp Sharpening System - Manual (Page 35)

run a small orbital sander with a synthetic
woven abrasive (similar to 3M pads)
across the surface in a cross pattern.
That imparts a nice look and removes
any blemishes. I do the same thing with
my cast iron surfaces and follow it up with
a coat of paste wax to keep surface rust
from forming.
Put shelf bracket holes on the inside of
the side pieces of your sharpening center
for an adjustable shelf. Make the drawer
however you wish. I used inexpensive
bottom mount runners for this one. The
drawer won’t be carrying much weight so
no need to use ball-bearing slides and
dovetailed construction unless you want
to.
Size the unit to hold the Work Sharp and
all the components and abrasives you
need plus room to hold a Drill Doctor for
sharpening all your twist type drill bits.
Once you start using the Work Sharp on
this movable sharpening center, you will
never again find a dull tool in your hands.