Catskill Craftsmen 1429 - Manual (Page 9)

STEP 4
Main Assembly Part 2
1 Assembled Back, 1 Assembled Front
1. With the back assembly from step 3 in the same position, fit the Assembled Front onto the braces,
lining up all the pins and bastion posts with holes.
2. Secure the Assembled Front to the braces using barrel nuts and set screws.
3. Tap in the caster sockets with a hammer. Then fit in the casters. Tap them into place with a
hammer if necessary.
4. Screw the Drawer Glides to the Drawer Glide Support with 5/8” #6 screws (first remove the
glide insert by pressing down on the black tab), line up the holes so that the glide slides out
towards the front. The glide should be attached so that it overlaps the back leg by about half of an
inch, and overlaps the front leg by just under two and a half inches.
ILLUSTRATION 4