Catskill Craftsmen 1582 - Manual (Page 10)

4 Used
in this step
This edge faces
the front of the
cart
STEP 6
ILLUSTRATION 6
9 Used
in this step
3/8” Phillips Pan Head #6 Screw
A. Tap/insert 3/4” pin into each edge of the center divider. DON’T OVERDRIVE PINS! Pins
should stick up about 1/4” when seated.
B. Attach the magnet with the 1/2” #4 screws to the top of the panel.
C. Attach full extention glides to the center divider as shown. Note that the glides should
slide out towards the same edge with the attached magnet.
D. Tap 1” steel pins into the left side of the center divider to be used as shelf supports in a
later step.
3/4” Long 3/16” DIA. Steel Pin
3/4” Pin
Left Side View Right Side View
4 Used
in this step
1” Long 3/16” DIA. Steel Pin
1” Pin
3/8” Phillips
Pan Head
#6 Screw