Catskill Craftsmen 1582 - Manual (Page 9)

STEP 4
A. Tap/insert ONE 1 1/2” pin into each end of the door. DON’T OVERDRIVE PINS! Pins should stick
up about 1/2” when seated.
B. Attach the magnet plate (may be stuck to magnet in the hardware pack!) with the 1/2” #4 screw
to the top of the door. Bumps go toward the wood, and the plate should be vertical.
C. Attach door handle with 1” truss head machine screws. Washers may be necessary to ensure a snug
fit.
ILLUSTRATION 4
STEP 5
A. Take the 2 front braces and tap/insert one 3/4” steel pin into each end of both braces until
seated. About 3/8” will stick out when seated. OK if loose.
ILLUSTRATION 5
1” Truss Head Machine Screw
2 Used
in this step
2 Used
in this step
1 1/2” Long 3/16” DIA. Steel Pin
4 Used
in this step
3/4” Long 3/16” DIA. Steel Pin
3/16” Flat Washer
2 Used
in this step