Catskill Craftsmen 1582 - Manual (Page 14)

STEP 12
A. Assemble top by placing the top and the drop leaf upside down on a smooth flat surface. Install
hinges using 5/8 #8 screws. The longer part of the hinge goes on the drop leaf with the short part on
the cart top. Fasten the drop leaf supports using 5/8 #8 screws. See illustration 12B.
B. Make a large ( X ) mark over each of the 4 pilot holes in the bottom. Make marks about 1/2-1” long.
These marks will help you align the cabinet with the pilot holes in the bottom of the Top.
C. Place the Cart Top on the cabinet. Open the outside doors. Maneuver the Cart Top so that the ( X )
marks/pilot holes in the bottom of the Top align with the holes in the “L” brackets. Secure top to “L”
brackets with 5/8” #6 screws.
ILLUSTRATION 12B
ILLUSTRATION 124A
STEP 13
A. Insert one 3/4” pin into the end of each
stemware holder. Orient holder as shown in
the illustration and put pins into holes in the
back panel.
B. Attach the stemware holders to the bottom
edge of the top front brace using 1” #8 screws.
4 used
in this step
1” Phillips Flat Head #8 Screw
3/4” Long 3/16” DIA. Steel Pin
4 used in this step
3/4” Long 3/16” DIA. Steel Pin
1” Phillips
Flat Head
#8 Screw
ILLUSTRATION 13
5/8 #8 screws
20 Used
in this step
5/8” Phillips Flat Head
#8 Screw
4 Used
in this step
5/8” Phillips Flat Head
#6 Screw
5/8 #6 screws
To attach “L”
Brackets