Catskill Craftsmen 51526 - Manual (Page 11)

1 3/4” Phillips Flat Head Bolt
2 Used in this step
10-24 Hex Nut
2 Used
in this step
2 Used
in this step
3/16” Flat Washer
STEP 11
A. Install doors by inserting pins in
the door tops into the holes in the
long edge of the top front brace.
B. Place one washer on each of
the door pins in the door bottoms.
C. Take the bottom front brace,
align pins in the door bottoms with
holes along top long edge of brace
(are washers on pins?) and secure
brace with 1 3/4” bolt/hex nuts as
before.
STEP 12
A. Stick magnet to magnet plate on right door.
B. With left door open, close the right door. The magnet should be positioned over the wooden block
on the bottom of the top front brace. Hold the magnet in place with your thumb, and open the right
door. The magnet will be in the correct position on the block.
C. Secure magnet with the two round head screws in the magnet packet. Center screws in the slots in
the magnet. This will allow adjustment later, if needed.
NOTE: No pilot holes in block as softwood!
Magnet
5/8” Pan Head Screw
2 Used
in this step