Catskill Craftsmen 51526 - Manual (Page 7)

STEP 5
A. Turn the side/back assembly (from step 1) upside down (invert) on top of the inverted table top.
B. Using the (X) marks from step 4 as a guide, insert the tips of the 5/8” #7 screws through the slots
in “L” bracket and into the pilot holes in the unit top and finger tighten. When all 4 screws are properly
aligned, tighten down.
C. Tap two 1” pins into each side panel. These pins will hold the bottom shelf.
4 Used in this step
1” Long 3/16” DIA. Steel Pin
PIN
PIN
5/8” Phillips Flat Head #7 Screw
(Used to attach
“L” brackets)