Step 3, Step 4 – Catskill Craftsmen 51526 User Manual
Page 6
STEP 3
A. Lay Back Panel flat on a smooth surface with holes up.
B. Attach Side Panels with 1 3/4” bolts and hex nuts. After inserting bolts(s) thru the holes in the Side
Panels, thru the holes in the long edges of the Back Panel, place a hex nut on the tip of your finger,
align nut with bolt and tighten.
C. Look ahead to step 5 which shows side panels attached to back panel.
NOTE: Make sure you position the side panels according to Drawer Glides (left or right).
STEP 4
STEPS 5 - 14 WILL BE ACCOMPLISHED WITH
THE UNIT TOP UPSIDE DOWN (INVERTED),
BUILDING UPWARD TOWARD THE BOTTOM/
CASTER END! BE CAREFUL AS PART
DESCRIPTIONS ARE BASED ON AN UPRIGHT,
COMPLETED UNIT!
Mark a Large (X) mark over each of the 4 pilot holes
in the bottom. Make marks about 1 1/2” long. These
marks will help you align the cabinet with the pilot
holes in step 5.