Step 1 – Catskill Craftsmen 51526 User Manual
Page 4
STEP 1
1. Attach the Rack Top to the top ends of the Side Panels (universal: same left/right & top/bottom)
using 1 1/4” #8 wood screws. MAKE SURE YOU HAVE THE RACK TOP! The only difference
between the Rack Top and the Cabinet Top is that the Cabinet Top has 4 small pilot holes on the
bottom side plus the 4 through holes; whereas, the Rack Top only has the 4 through holes.
NOTE: On the Rack Top the countersunk (reamed out) through holes face up and the countersunk
holes/pilot holes on the Cabinet Top face down. The countersunk holes allow the screw heads to be
flush with the wood surface when tightened down.
2. Turn this assembly upside down so that the Rack Top is on a smooth flat surface. Attach the
Cabinet Top with four 1 1/4” #8 wood screws. With the unit upside down at this point, the 4 pilot holes
should be up. See illustration 1B.
3. Leave this assembly UPSIDE DOWN and go to STEP 2.
NOTE: The cart cabinet will be constructed upside down
using the bottom of the Cart Top as the base.
1 1/4” Phillips Flat Head #8 Screw
8 Used in this step
RACK TOP
CABINET TOP
PILOT HOLES HIDDEN
CABINET TOP
RACK TOP
ILLUSTRATION 1A
ILLUSTRATION 1B