Catskill Craftsmen 51526 - Manual (Page 12)

STEP 13
A. Insert and tap caster sockets with hammer
until the teeth grab the wood. DON’T POUND
SOCKET FLAT OR CASTER SHAFT WILL
NOT ENTER.
B. Insert casters and seat by pushing straight
downward with heel or your hand, or tap into
place with a hammer. Don’t be afraid to give
them a good downward whack on the solid
metal part of the caster!
C. Locking wheels usually go on front.
STEP 14
A. Upright Unit. Take bottom shelf
(no edge banding) and place it on
the set of back pins. Close doors and
shelf will drop into place.
B. Decide on position of middle
shelf, then tap two 1” pins into each
side panel, making sure the pins on
both sides are in the same relative
position. To remove a pin, use
pliers or claw hammer.
C. Place middle shelf, edge banding
out, on pins.
D. Insert drawer. If drawer front hits
the bottom of the cabinet tap on the
top front brace or tap top front brace
down. Loosten bolts as necessary.
When drawer moves freely,
retighten all bolts!
E. Tap wooden disks into sides.