Catskill Craftsmen 51526 - Manual (Page 9)

STEP 7
Take the 2 front braces and tap/insert one 3/4”
steel pin into each end of both braces until seated.
About 3/8” will stick out when seated. Ok if loose.
4 used in this step
3/4” Long 3/16” DIA. Steel Pin
Side Panel Leg
Inside Brace
Countersunk Hole in Leg
( disk goes in this hole to
hide bolt head! )
Nut Access Hole
Hex Nut
2 used in
this step
1 3/4” Phillips Flat Head Bolt
2 used
in this step
10-24 Hex Nut
1 3/4” #8 Bolts
Insert Brace Pins Here
Glide Support
Assembly
STEP 8
A. Take the top front brace (with magnet block),
insert the pins in the brace ends into the slots on
the inside of the front legs and slide down until the
brace aligns with the bolt hoes as illustrated. The
pin holes for the door pins and the magnet block
will be up. Secure with 1 3/4” bolts/nuts.