GW Instek GDS-2000A series User Manual - Manual (Page 244)

GDS-2000A Series User Manual
244
The calibration for Channel 1 starts and ends
automatically, in less than 5 minutes. A
message is displayed when the calibration
procedure has ended.
9. Repeat the above step for Channel 2, 3* and 4*
when prompted.
*4 channel models only.
10. When the calibration for all channels has
completed, the display goes back to the default
state.
Probe Compensation
Panel Operation 1. Connect the probe between the Channel 1 input
and the probe compensation output (Demo 3
output, by default set as 2Vp-p, 1kHz square
wave) on the front panel. Set the probe
attenuation to x10.
2. Alternatively, the probe compensation signal
can be changed. See page 171 for details.
POSITION
CH1 Demo
x1
x10
X 1 0
X 1
CH1
Demo