Document Outline

• SAFETY INSTRUCTIONS
  • Safety Symbols
  • Safety Guidelines
  • Power cord for the United Kingdom
• GETTING STARTED
  • GSP-730 Introduction
    • Main Features
    • Package Contents
  • Appearance
    • GSP-730 Front Panel
    • Rear Panel
    • Display
  • First Time Use Instructions
    • Tilting the Stand
    • Power UP and Down
    • Software Update
    • USB Driver Installation
    • Restoring Default Settings
    • Conventions
• BASIC OPERATION
  • Frequency Settings
    • Center Frequency
    • Start and Stop Frequency
    • Center Frequency Step
  • Span Settings
    • Span
    • Full Span
    • Zero Span
    • Last Span
  • Amplitude Settings
    • Reference Level
    • Amplitude Units
    • Scale/Div
  • Autoset
    • Using Autoset
    • Limiting the Autoset Vertical Search Range
    • Limiting the Autoset Horizontal Search Range
  • Marker
    • Activating a Marker
      • Activate a Normal Marker
      • Activate a Delta Marker
      • Move Marker Manually
      • Move Marker to Preset Locations
    • Move Marker to Trace
      • Turn All Markers On or Off
    • Show Markers in Table
    • Peak Search
      • Move Marker to Peak
      • Move Marker and Peak to Center
      • Search for Peaks
    • Peak Table
  • Measurement
    • Channel Analysis Overview
      • ACPR
      • OCBW
  • Limit Line Testing
    • Activate a Limit Line
    • Creating a Limit (Point by Point)
      • Pass/Fail Testing
  • Bandwidth
    • Resolution Bandwidth Setting (RBW)
  • Trace
    • Selecting a Trace
    • Trace Math
    • Average Trace
  • Display
    • Adjusting the LCD Brightness
    • Setting a Display Line (Reference Level Line)
    • Using the Video Out Port
    • Split Spectrum View
  • Save/Recall Files
    • Save/Recall Setup
    • Save/Recall Trace Data
    • Save/Recall Limit Lines
    • Saving an Image File (Hardcopy)
      • Hardcopy Setup
    • Load Default Settings
  • System Settings
    • System Information
    • System Language
• REMOTE CONTROL
  • Interface Configuration
    • Configure Remote Interface
    • Remote Control Function Check
  • Command Syntax
  • Command List
    • IEEE488.2 Standard Commands
    • Sweep Commands
    • Frequency Commands
    • Span Commands
    • Amplitude Commands
    • Marker and Peak Search Commands
    • Trace Commands
    • Power Measurement Commands
    • Limit Line Commands
    • BW Commands
    • Display Commands
    • Preset Commands
    • System Commands
• FAQ
  • I connected the signal but it does not appear on screen.
  • The trace is updated too slowly on the screen.
  • I cannot see the trace on the screen.
  • The performance does not match the specification.
• APPENDIX
  • GSP-730 Default Settings
  • GSP-730 Specifications
    • Frequency
    • Amplitude
    • Sweep
    • General
    • Other
  • GSP-730 Dimensions
• INDEX