GW Instek AFG-100/200 Series User Manual - Manual (Page 15)

GETTING STARTED
15
Module Installation/Removal
Background The AFG-125/225 modules are installed into the
area that is left between both of the DS2-FH1
housings.
Note Make sure the power is turned off before installing the
AFG-125/225 module.
Installation Steps 1. Slide the module into the slot that was created
between the DS2-FH1 housings. The front of
the module should be facing forwards.
2. Make sure the module is secure. The module
will click into place when it is inserted
properly.
3. Make sure the GDS-2000A is turned off before
proceeding.
4. Connect one end of the GTL-254 USB cable to
the rear panel USB Device port and to the USB
Host port. Connect the other end to the Device
port on the AFG-125/225, as shown below.
5. Turn the power back on. The AFG-125/225 will
now be accessible in the Option menu.