GW Instek AFG-100/200 Series User Manual - Manual (Page 29)

OPERATION
29
Turning the Output On
Background The AFG-125/225 can output 5 different types of
basic waveforms: Sine, Square, Pulse, Ramp,
Noise.
The basic waveforms can be output as is or they
can be used as the baseband waveforms for the
modulation functions or as the primary waveforms
for the sweep and burst functions.
Connection 1. The AFG-125/225 arbitrary function has 2
output channels, CH1 and CH2. Each output
can be selected individually.
2. Connect a BNC cable
to the appropriate
output (CH1 or CH2).
Steps 1. Press the Output Setup key to set
the amplitude.
2. From the side menu choose the
output parameters
Choose the signal that will be
output:
Signal 1:
Signal 2: CH1
CH2
Turns the output of the selected
signal on/off.
Sets the output impedance to 50Ω or
High Z.