GW Instek LCR-8000G Series - Manual (Page 41)

PASS-FAIL MODE
81 81 81 81
3. In Manual (single) mode press F1
(Start) or the Trigger key to
manually start the program. The test
results show up according to the
program contents.
Trig
F 1
Manual (single) Mode
4. In Auto trigger mode, it will
autoscan continuously and will not
start until a DUT has been detected.
To manually trigger the program,
press F1 (Start) or the Trigger key. Trig
F 1
MULTI STEP MODE
PROGRAM: Demo Run –
Start
SET
1
2
3
4
Freq
1.2000k
10.000k
100.00k
DC
Volt
1.00
1.00
1.00
1.00 Ls
Q
Ls
Rdc
Result
9.8936mH
22.708 Q
10.852mH
25.555 ? LO
PASS
HI
PASS
FAIL FAIL FAIL FAIL
A u t o s c a n n i n g . . .
Auto trigger (repetitive) mode
LCR-8000G Series User Manual
82 82 82 82
The rightmost row shows the result for each
step.
Failed: below the Lo limit
Failed: above the Hi limit
Passed
The left bottom corner shows the result for the
whole program.
PASS PASS PASS PASS All steps passed
FAIL FAIL FAIL FAIL
One or more steps failed
5. To return to the program setting
menu, press F6 (Set).
F 6