GW Instek LCR-8000G Series User Manual
Page 55
REMOTE CONTROL
109
109
109
109
Configure GPIB interface
Connection
Connect the GPIB cable to the
rear panel port: 24-pin female
connector.
Pin assignment
12
1
24
13
Pin1 Data line 1
Pin13 Data line 5
Pin2 Data line 2
Pin14 Data line 6
Pin3 Data line 3
Pin15 Data line 7
Pin4 Data line 4
Pin16 Data line 8
Pin5 EOI
Pin17 REN
Pin6 DAV
Pin18 Ground
Pin7 NRFD
Pin19 Ground
Pin8 NDAC
Pin20 Ground
Pin9 IFC
Pin21 Ground
Pin10 SRQ
Pin22 Ground
Pin11 ATN
Pin23 Ground
Pin12 Shield (screen)
Pin24 Signal ground
GPIB constraints
•
Maximum 15 devices altogether, 20m cable
length, 2m between each device
•
Unique address assigned to each device
•
At least 2/3 of the devices turned On
•
No loop or parallel connection
LCR-8000G Series User Manual
110
110
110
110
Select GPIB
address
1. Press the Menu key and F5 (System).
The system configuration appears.
Menu
F 5
2. Press the Up/Down key and move
the cursor to GPIB.
5
GPIB address
:
3. Use the numerical keys to enter the GPIB
address, 1 ~ 30.
30
GPIB address
:
Address 5
Enter