GW Instek GDM-8261 User Manual - Manual (Page 141)

REMOTE CONTROL
141
Configure Ethernet Interface (RESET)
Background The RESET command is used to reset the Ethernet card
when new settings have been made. When the DHCP, IP,
subnet, gateway or DNS settings have been edited, use
the RESET command to validate the changes and reset
the Ethernet card to the new configuration settings. New
Ethernet configuration settings are only updated after the
Ethernet card has been reset.
Ethernet port
configuration 1. Press the Shift key, the 2nd
(Menu) key, the Left key
repeatedly until the SET LAN
configuration menu appears.
Note: SET LAN will only be
available after LAN has been
activated in the I/O menu, see
page 139.
/ EXIT SHIFT
2ND
MENU
HOLD
2. Press the Down key. The
RESET selection display
appears.
3. Press the Down key. The
RESET YES/NO selection
appears.
4. Press the Up/Down key to
select YES or NO. YES will
reset the Ethernet card, NO will
cancel resetting the card.