In-Situ Aquaculture Buoy Manual (purchased after 28 May 2013) - Manual (Page 31)

31
Database
The database enables setup and changes to farm configuration. Do not make changes
to the database unless you are very familiar with the system and how it works. The
database allows an administrator or installation engineer to do the following actions.
l
Add sensors
l
Renumber sensors
l
Set limits by device
l
Adjust ON limits
l
Adjust OFF limits
l
Set minimum dissolved oxygen limits
l
Set minimum amperage limits
l
Renumber groups
After changes are made to the database, you must close and then
restart Aquasoft in order for the changes to take effect.
1. To access the database, click the Config menu and select Database
2. Enter your password.
Figure 18.1 Database view