In-Situ Aquaculture Buoy Manual (purchased after 28 May 2013) - Manual (Page 20)

20
Figure 9.2 Digi X-CTU software, Terminal tab
12. Type atid followed by the 4-digit ID number (e.g. atid3456) and click Enter.
13. Type atwr and click Enter.
14. Disconnect the programming module from power and the computer.
15. Remove the radio from the programming module.
16. Align the radio pins with the sockets on the buoy board and press the radio into
place.
17. Ensure that a fresh desiccant pack is installed. See page 21.
18. Replace the housing and attach the cables.