In-Situ Aquaculture Buoy Manual (purchased after 28 May 2013) - Manual (Page 16)

16
Connecting Power to the Transceiver and Buoy
1. Use a screwdriver to remove the cover from the battery box.
Figure 7.1 Top of buoy with battery box cover removed
2. Connect the black lead to the black terminal.
3. Connect the white lead to the red terminal. If the system is functioning properly, you
will hear the brush motor power on for a few seconds.
Figure 7.2 Buoy battery power + and - connections
4. Replace the battery box cover.
Programming Module Purchased Separately
A programming module (0085410) is necessary for programming the radios with the
network settings.
Figure 7.3 Programming module with radio installed