In-Situ smarTROLL RDO Handheld Operators Manual - Manual (Page 13)

13
4. Close the cover and slide the lever to lock the compartment.
Installing the Sensor and Cable
1. Twist the restrictor off the probe.
2. Remove the dust cap from the sensor lens.
3. Locate the RDO Sensor Cap container and remove the cap from the packaging.
Important: Avoid touching the sensor lens and the sensing
material on top of the cap.
4. Align the flat edge of the RDO Sensor with the slotted edge of the RDO Cap and
press the cap into position. Push until the cap is firmly in place.
5. Twist the restrictor onto the probe.
6. Remove the dust cap from the cable connector.
7. Align the pins on the cable with the pins on the probe, then twist the outer portion of
the connector until the connection is secure.