Jenway 4510 User Manual
Page 20
6.4 Printing
A 32 column serial printer (037 701) is available for use with the Model 4510.
Connect the printer via the cable supplied with the printer to the 9 way socket located on the rear
panel of the instrument.
To intiate a print out of data press the print key.
When the first print is performed a header section will be printed showing:
Instrument name
Spacing for entry of Operator & User ID
Most recent calibration information (Cell Constant)
Reference temperature
Temperature coefficient
TDS EC ratio
This will be followed by results data in either µS / mS (Conductivity) or mg/l / g/l (TDS) dependent
on mode selected. Details will also be given on temperature.
An asterisk (*) after the sample number indicates that an endpoint has been reached.
Each reading will be numbered sequentially.
A calibration will reset the data number to 0001 and the header information will be re-printed.
To obtain a print out of stored readings, enter the RESULTS MODE and press the print key. A print
out of all 32 print locations will then be generated.
17
451 050/REV A/03-03