KROHNE VFM 3100 EN - Manual (Page 16)

16
Electronic module
(see detail „A”)
See table 7 for details
of this connection
Disconnect
this end when
installing.
See table 5
for dressing of
cable at this end.
Outside braid makes contact to
housing. Braid is compressed for a
good electrical connection.
See table 6 and 7.
1/2 inch conduit may be connected
directly to connectors via 3-piece
union/coupler.
Cable must be pushed into stainless steel
fittings when installing compression nuts
to ensure that the braid is properly seated
for a good electrical connection (both ends).
See tables 6 and 7.
See table 5 for
dressing of cable
at this end.
VFM 3100 body.
External earth (ground)
connection screw –
cenelec flameproof only.
Pre-assembled and dressed
junction box
Braided shield and drain wire must
be in contact at this end of cable.
Note: do not disassemble to install.
Remote
cable
Output
signal
wires
brown
red
orange
yellow
Detail “A”
Figure 9. Overall View of Remote Mounted VFM 3100