KROHNE OPTISYS TUR 1050 EN - Manual (Page 36)

5
OPERATION
36
OPTISYS TUR 1050
www.krohne.com 11/2012 - 4002444301 MA OPTISYS TUR 1050 R02 en
5.7.1 Selecting the output
After switching to the configuration mode, the first submenu is always the selection of the
output. At first you see the following display:
• Select the desired output by using ↓ or ↑ (options: 4-20 for the 4...20 mA output, 485 for the
RS 485 output, OFF if you do not need outputs) or leave the setting.
The displays for the two possible outputs look like the following drawings:
• Accept your selection by pressing ^.
i If you chose or leave the setting "OFF", the device switches to the submenu "Error level"; if
you chose or leave one of the outputs, the device switches to a submenu for the settings of
the chosen output (see one of the next two sections).
AUTO
CAL
CONFIG
AUTO
CAL
CONFIG