KROHNE OPTISYS TUR 1050 EN - Manual (Page 44)

5
OPERATION
44
OPTISYS TUR 1050
www.krohne.com 11/2012 - 4002444301 MA OPTISYS TUR 1050 R02 en
Ultrasonic cleaning
With the help of this function you turn the ultrasonic cleaning on or off (default is "On").
RS 485 parameters
The RS 485 parameters are only adjustable and so appear if the RS 485 interface is enabled (for
detailed information refer to
Selecting the output on page 36). In this case you can change the
parameters "BITS", "PRTY" (parity) and "STOP" (stop bit). After choosing a setting for the
ultrasonic cleaning in the previous step you see the following display at first:
• Use ↑ or ↓ to select the desired number of bits or leave the setting, accept your selection by
pressing ^.
• Use ↑ or ↓ to select the desired parity or leave the setting, accept your selection by
pressing ^.
• Use ↑ or ↓ to select the desired number of bits or leave the setting, accept your selection by
pressing ^.
i The device switches to the next item of the extended settings (desiccant alarm).