KROHNE BATCHFLUX 5015 K EN - Manual (Page 25)

Installation and operating instructions 25 BATCHFLUX
4.5 Error messages in measuring mode
The following list gives all errors that are likely
to occur during process flow measurement.
Errors are shown in the display when “YES“ is
set in Fct. 1.4 DISPLAY, subfunction
“DISP.MSG.“.
Error message Discription of error Error clearance
LINE INT. Power failure
Note:
no counting during power failure Delete error message in RESET/QUIT
menu. If necessary, reset totalizer.
PULS.OUTP. P Pulse output overranged.
Note:
totalizer deviation possible. Check instrument parameters and
correct, if necessary. After cause has
been eliminated, error message is
deleted automatically.
ADC Analog/digital converter
overranged. After cause has been eliminated, error
message is deleted automatically.
FATAL. ERROR Fatal Error; all outputs set to
“Min. values“. Please consult factory.
TOTALIZER Totalizer has been reset. Delete error message in RESET/QUIT
menu.
4