KROHNE BATCHFLUX 5015 K EN - Manual (Page 3)

Installation and operating instructions 3 BATCHFLUX
Part C Special applications, functional checks, and service
36 - 42
6 Special
applications 36
6.1 RS 232 adapter and KROHNE software (option) 36
6.2 Operation via HHT 010 hand-held terminal (option) 36
7
Functional checks 37 - 39
7.1 Zero check with signal converter IFC 015 37
7.2 Test of measuring range Q, Fct. 2.1 38
7.3 Hardware information and error status, Fct. 2.2 39
8 Service
40 - 41
8.1 Important advice for removing the flowmeter from the pipeline – PLEASE NOTE 40
8.2 Removal from the pipe system 40
8.3 Removal of the electronics unit 41
8.4 Restart 41
9
Illustrations of printed circuit boards 42
Part D Technical Data, block diagram and measuring principle
43 - 49
10
Technical data 43 - 47
10.1 Flow during filling and fill volume 43
10.2 Flowmeters 43
10.3 Signal converter 44
10.4 Error limits at reference conditions 45
10.5 Dimensions and weights 46 - 47
10.6 Instrument nameplates 47
11 Block
diagram 48
12 Measuring
principle 49
Part E Annex 50 - 52
E1 Index
50 - 51
E2 Form to accompany returned device 52
Please note!
Do not open the housing of the BATCHFLUX IFM 5015 K.
Danger of contamination with substances likely to destroy the moisture barrier of the electronic
equipment (e.g. if CIP or SIP cleaned from the outside).
Therefore, please contact your KROHNE Service engineer before you open the housing.