KROHNE OPTIWAVE 5200 FOUNDATION FIELDBUS - Manual (Page 28)

4
OPERATION
28
OPTIWAVE 5200 C
www.krohne.com 09/2013 - 4002500101 - AD FF OPTIWAVE 5200 R01 en
FD_OFFSPEC_ACTIVE FD_OFFSPEC_ACTIVE FD_OFFSPEC_ACTIVE FD_OFFSPEC_ACTIVE
Offspec Active Offspec Active Offspec Active Offspec Active
R This parameter reflects the error conditions that are being
detected as active as selected for this category. It is a bit
string, so that multiple conditions may be shown.
Setting:
• (00) Check Function
• (01) Cond01
• (02) Cond02
• (03) Cond03
• (04) Cond04
• (05) Cond05
• (06) Cond06
• (07) Bad Measurement quality
• (08) Signal Strong
• (09) Signal Weak
• (10) Empty Spectrum invalid
• (11) Sensor No Signal
• (12) Sensor Microwave Error
• (13) Temperature Above +75°C
• (14) Temperature Below -35°C
• (15) Overfill Warning
• (16) Level Lost warning
• (17) Temperature out of range (warning)
• (18) Local operation
• (19) Overfill Error
• (20) Level lost error
• (21) Temperature out of range Error
• (22) Converter Voltage Error
• (23) Converter ROM Error
• (24) Converter RAM Error
• (25) Converter EEPROM Error
• (26) Sensor not compatible
• (27) Internal Communication Error
• (28) Sensor Voltage Error
• (29) Sensor ROM Error
• (30) Sensor RAM Error
• (31) Sensor EEPROM Error
FD_OFFSPEC_ALM FD_OFFSPEC_ALM FD_OFFSPEC_ALM FD_OFFSPEC_ALM
Offspec Alarm Offspec Alarm Offspec Alarm Offspec Alarm
This parameter is used primarily to broadcast a change in the
associated active conditions, which are not masked, for this
alarm category to a Host System.
UNACKNOWLEDGED
Unacknowledged
RW A discrete enumeration which is set to Unacknowledged when
an alarm occurs, and set to Acknowledged by a write from a
human interface device or other entity which can acknowledge
that the alarm/event has been noticed.
Uninitialized
Setting:
Uninitialized / Acknowledged / Unacknowledged
ALARM_STATE
Alarm State
R A discrete enumeration which gives an indication of whether
the alert is active and whether it has been reported.
Uninitialized
Setting:
Uninitialized / Clear - reported / Clear - not reported / Active -
reported / Active - not reported
Parameter Parameter Parameter Parameter
DD name Access Description and settings Initial Value