KROHNE OPTIWAVE 5200 FOUNDATION FIELDBUS - Manual (Page 33)

OPERATION
4
33
OPTIWAVE 5200 C
www.krohne.com 09/2013 - 4002500101 - AD FF OPTIWAVE 5200 R01 en
DIAGNOSTIC_VALUE
Diagnostic Value
R Current field diagnostic condition. Uninitialized
Setting:
• (00) Check Function
• (01) Cond01
• (02) Cond02
• (03) Cond03
• (04) Cond04
• (05) Cond05
• (06) Cond06
• (07) Bad Measurement quality
• (08) Signal Strong
• (09) Signal Weak
• (10) Empty Spectrum invalid
• (11) Sensor No Signal
• (12) Sensor Microwave Error
• (13) Temperature Above +75°C
• (14) Temperature Below -35°C
• (15) Overfill Warning
• (16) Level Lost warning
• (17) Temperature out of range (warning)
• (18) Local operation
• (19) Overfill Error
• (20) Level lost error
• (21) Temperature out of range Error
• (22) Converter Voltage Error
• (23) Converter ROM Error
• (24) Converter RAM Error
• (25) Converter EEPROM Error
• (26) Sensor not compatible
• (27) Internal Communication Error
• (28) Sensor Voltage Error
• (29) Sensor ROM Error
• (30) Sensor RAM Error
• (31) Sensor EEPROM Error
ENABLE_DISABLE
Simulate En/Disable
RW Enable/disable simulation. Uninitialized
Setting:
Unitialized / Disabled / Active
FD_VER FD_VER FD_VER FD_VER
Revision Revision Revision Revision
R The major version of the Field Diagnostics specification used
for the development of this device.
1
PASSWRD PASSWRD PASSWRD PASSWRD
Password Password Password Password
RW Password to activate access rights to restricted parameters 0
PROTECT_INFO PROTECT_INFO PROTECT_INFO PROTECT_INFO
access protection access protection access protection access protection
R Setting:
bit 5...7: not use / User / Service level / Production / Custody
Transfer / Write Lock
Production
SERIAL_NUMBER SERIAL_NUMBER SERIAL_NUMBER SERIAL_NUMBER
Seriennummer Seriennummer Seriennummer Seriennummer
R Device serial number, serial number of the system.
SW_SIMULATE SW_SIMULATE SW_SIMULATE SW_SIMULATE
SW Simulation SW Simulation SW Simulation SW Simulation
RW Enable/disable simulation like simulate hardware jumper. Disabled
Setting:
Disabled / Active
Parameter Parameter Parameter Parameter
DD name Access Description and settings Initial Value