KYORITSU 8113 - Manual (Page 7)

― 5 ―
might be at ground potential. Keep your body isolated from
ground by using dry clothing, rubber shoes, rubber mats, or
any approved insulating material.
5. DO NOT make battery replacement with power switch set to
ON position and test leads connected to instrument.
6. DO NOT use Model 8113 on a circuit with a voltage of higher
than 600V AC.
7. DO NOT expose it to the direct sun, extremes of temperature
and humidity or dew fall.
CAUTIONS
1. When not in use for a long period of time, place the
instrument in storage after removing the batteries from it.
2. Never make measurements if the instrument, the test leads or
your hand is wet.
3. Calibration and repair of any instrument should only be
performed by qualified and trained service technicians.
4. Do not install substitute parts or perform any unauthorized
modification of the instrument. Return the unit to Kyoritsu or
your distributer for repair.
5. Use a damp cloth and detergent for cleaning the case of the
on the instrument. Do not use abrasives or solvents.
6. Always set the Range Selector Switch to the OFF position
after use.
7. The instrument must be used by a competent, trained person
and operated in strict accordance with the instructions.
Kyoritsu will not accept liability for any damage or injury
caused by misuse or noncompliance with the instructions or
safety procedures. It is essential to read and understand the
safety rules contained in the instructions. They must be
observed when using the instrument.