Introduction – Martel Electronics BetaGauge PIR PRO User Manual
Page 3
1. Introduction
The BetaGauge PI Reference Class (PIR) combines the high
accuracy of digital electronics with the convenience and ease of
use of an analog test gauge. Accurate to ± 0.04% of reading, the
BetaGauge PIR can be used as a calibration reference, or in any
application where high accuracy pressure measurement is
required.
Many user configurable functions have been designed into the
BetaGauge PIR including sampling rate, TARE, damping, auto
shut off, and min-max. Once the gauge is configured, settings can
be locked and password protected to prevent unauthorized
changes to configuration.
1.1 Customer Service
Corporate Office:
www.martelcalibrators.com
e-mail: [email protected]
Tel: (603) 434-1433 800-821-0023 Fax: (603) 434-1653
Martel Electronics
3 Corporate Park Drive
Derry, NH 03038
1.2 Standard Equipment
Check to see that your BetaGauge PIR has arrived intact. Batteries
are factory installed unless you have purchased the optional 24V
powered version, in which case batteries are not supplied or
installed. Save the packing materials at least until you have
verified that there is no concealed damage.
1.3 Safety information
A Warning identifies conditions and actions that pose hazard(s) to
the user; a Caution identifies conditions and actions that may
damage the Calibrator or the equipment under test.
Symbols Used
The following table lists the International Electrical Symbols. Some
or all of these symbols may be used on the instrument or in this
manual.
1