Martel Electronics M2000 - Manual (Page 4)

4
4 Primary Function Keys
VOLTS/mA Toggles through the Voltage and mA output ranges.
STBY/OPR Toggles between standby and operate modes.
2nd The “second function” key allows the use of the features
described by the second function keys.
CE The “clear entry” will clear the display if a mistake is made
during data entry.
5 Secondary Function Keys These keys perform second functions after the 2nd key has
been pressed.
CAL Used to set LCD contrast, backlight and interface
parameters RS-232 or GPIB (2001A).
For a complete electrical calibration the RS-232 mode is
used. Contact factory for more information.
SET Used to set a setpoint.
See
Section IX RCL Used to recall a setpoints.
AUTO Used to initiate auto setpoint.
See Section X LOCAL Used to regain local control.
6 Output Binding Posts These binding posts are made of a special copper alloy to
reduce thermal EMF’s. These posts support the use of
both standard banana plugs or discreet wires.
7 Display The 16 character by 2 line display is backlit and provides
all visual user feedback.
7A Range Field Displays the range and setpoint number if applicable.
7B OPR/STBY Displays the output state.
7C Unit Field Displays output units.
7D Value Field Displays output value.