NSi Industries DG180 Old Series - Manual (Page 5)

Press mode key until display shows DATE.
Press MONTH key to select month. Press DATE key
to set today’s date. Press YEAR key to set present
year. Press ENTER key. Unit now stores present
date.
Note: If unit has correct entry for the calendar, then
the unit will go into the SET mode. If the calendar has
an incorrect entry, then the unit will stay in the DATE
mode, with MM--YY displayed, signifying that the
date does not correspond with the month, and/or
year, i.e. Feb. 31,1989. If this occurs, set the correct
date, and then press ENTER.
TO SET SCHEDULE
For convenience, write out your desired schedule on
a separate piece of paper. If display does not show
SET then press MODE key until display shows SET.
The display will show 12:00 AM.
1. Press HOUR key to set hour (check AM/PM)
2. Press MIN key to set minutes
Note: Minutes advance in intervals of 5 because
scheduling execution has 5 minute resolution.
5
DATE
AM
SET
3. Press ON/OFF key to set ON or OFF event.
4. Press ENTER key to store the event.
REPEAT ABOVE STEPS FOR ALL DESIRED
EVENTS
Note: After each event is entered, the clock (in the
set mode only) automatically advances 5 minutes.
5. Press MODE key to return to RUN mode.
Note: When the unit is returned to the run mode,
check the load status of the current setting. If it is
showing OFF but should be ON, press the over-
ride key since the unit does not “look back” to
the setting just entered. However, the unit will
correct itself at the nest scheduled event and no
further alteration will be necessary.
TO SET SKIP DAYS
1. Press MODE key until display shows SP
2. Press DAY/MONTH key and SU starts flashing.
3. If you want Sunday to be a skip day, press SP
DAY key and SU will remain solid. Next day (MO)
will begin flashing. If you do not want Sunday to
be a skip day, press DAY/MONTH key to advance
to the first desired Skip Day. Then press SP DAY
key.
4. If you want to delete a previously set skip day, press
DAY/MONTH key to advance to that day - then
(when Flashing) Press SP DAY key to delete it.
Summary: SP DAY key sets a flashing day as a
SKIP day and also eliminates a constantly dis-
played day from Skip day status. DAY/MONTH
key advances the days.
5. When all selected skip days are displayed as con-
stant. Press ENTER key. Unit goes to run mode
and clock shows real time. Skip day(s) will flash
when its day of the week is reached.
6