NSi Industries DGM100 Old Series - Manual (Page 7)

MLI-98(A)
TORK ®
1 GROVE STREET, MT. VERNON, NY 10550 TEL: 914-664-3542
FAX: 914-664-5052
MODIFY: During the review process, the DAY
HOUR, MIN. and ON/OFF keys can all be used to
modify the settings. You can use the first three keys
to modify when the event will take place, and the
ON/OFF key to change an ON pulse to an OFF
pulse, or visa-versa. ONCE YOU HAVE MADE THE
NECESSARY CHANGE, YOU MUST PRESS THE
ENTER KEY TO STORE THEM.
ADD: You may add events at any time by pressing
the mode key until the unit is in the set mode. Then
press ENTER key to advance to the next open set
point. Enter new schedule as indicated in section “To
Set Schedule”.
DELETE: If you choose to delete a schedule, simply
modify the HOURS and MINUTES, until the time dis-
play reads --:--. This will occur after scrolling past 11
P.M. with the HOUR key and “59” with the MIN key.
Then press ENTER to delete the event.
OVERRIDE
In order to temporarily change the current ON or OFF
status of a load, simply press the override key. This
can only be done when the unit is in the RUN mode.
The load status will flash indicating that this is a
change from a scheduled event.
In order to cancel the override, press override key
again.
7