NSi Industries DW200B - Manual (Page 5)

Press MONTH and DATE to set holiday 1 and then
press ENTER. The display will show:
To delete any holiday press DEL and press
ENTER.
NOTE:
a.
A total of 24 holidays can be set, all following the
same schedule.
b. For any holiday to be used, the MONTH and DATE
must be preset.
5.0 SCHEDULE SET MODE
Press MODE until display shows:
Press SELCT to select channel 1 or 2.
5.1 SETTING HOURS AND MINUTES
a. Press HOUR and MIN to set desired time.
b. Press EVENT to set desired event.
5.2 SETTING DAYS AND HOLIDAY
Press SELCT to select the flashing desired days
and/or holiday, otherwise press DAY to skip and
then press ENTER. To delete entry, press DAY until
previously selected entry flashes, press SELCT
and then press ENTER. The display will show:
6
MO TU WE TH FR SA SU H
CH1 2 3 4 ASTRO SEASON 1 2 3 4
SIG1 SIG2 CLK DATE SCH
CH1 2 3 4 ASTRO SEASON 1 2 3 4
SIG1 SIG2 CLK DATE SCH
INSTRUCTIONS FOR SETTING THE UNIT
Connect unit to main power source prior to entering the
settings. When powering up the unit for the first time,
allow 1-2 minutes to charge the supercap and the dis-
play will show 12 HOUR.
Press HOUR to change to 24 hour (military format) or
Press ENTER to set 12 hour (AM/PM format).
NOTES:
1. During the RUN mode, the Hour, Minutes, Seconds,
Day of week and flashing colons will be displayed.
2. The unit will not go into run mode unless the clock
and date is set. In any other mode, if no entries are
made for 5 minutes, the unit will automatically go to
the run mode.
3. Unit will display “PF” (Power Failure) in the absence of
AC power. A minimum of 8 hours is required to fully
charge the super cap.
4. When previously programmed unit comes back from
a power failure, it will “look back” and update the
schedule, executing the last scheduled event. If a sig-
nal setting was scheduled, after power failure the unit
will execute the last scheduled signal. Settings can be
manually updated by pressing the EVENT key in the
run mode.
After pressing ENTER the unit will display:
3
SIG1 SIG2 CLK DATE SCH
NOTE: AFTER MAKING ANY CHANGES TO THE
PROGRAM, PRESS MODE TO GO TO RUN MODE
AND THEN PRESS EVENT TO UPDATE THE LOAD
STATUS.
DW200B 3/21/07 11:44 AM Page 9