NSi Industries E120B User Manual
Page 9
7.0
NOTES:
1. MAN mode: Under this mode the unit disre-
gards the settings in the schedule mode and
remains in its manually set status ON or OFF.
NOTE: To resume regular schedule execution
press the mode key to return to AUTO mode.
2. Unit will go to RUN MODE automatically
(except on the MAN mode) if no key is pressed
for five minutes.
3. Clear all memory. All memory can be cleared
using the following procedure: While in the RUN
mode, press ENTER, display will show:
Use EVENT key to display:
Now press ENTER briefly and everything in the
timer memory will be erased, including real time
and date. NOTE: Unit has permanent memory
and will not be erased unless done through proce-
dure above.
5. Upon powering up your E101B/103B/120B the
display will show at what frequency the unit is
operating, 50 will determine 50Hz or 60 for
60Hz. NOTE: While in the AUTO mode, if AC
power is absent, the display will show a PF
(power failure) instead of the seconds scrolling
up.
6. A “Lo” on the display indicates that the super
cap has run low and the unit needs to be pow-
ered with AC. A minimum of 8 hours is required
to fully charge the super cap.
7
ON
OFF
CLK DATE SCH
AUTO
MAN
ON
OFF
CLK DATE SCH
AUTO
MAN
E101B SINGLE 7/22/07 10:02 PM Page 9