SHIMPO FGS-100E - Manual (Page 10)

9
6. Movement
6.1. Basic Movement
Take sufficient care while aligning, as there is potential of catching a hand, finger or
clothes in the Stand which would cause injury.
Test Stand Power Cord is connected to outlet as well as
Force Gauge power Adapter. Turn on Force Gauge.
Test Stand Power Cord is connected to outlet as well as
Force Gauge power Adapter. Turn on Force Gauge.
Once on, the display will indicate the model number,
then will show the speed setting as shown below.
(Example) Tension Test of Wire.
Crimped Terminal. Power Supply.
Wedge Chuck
(OPTIONAL)
MODE (Measuring Method) Setting.
Select the Movement Mode, matching to your required test needs.
Movement Mode
Press the PUSH Key or PULL Key to cycle through Manual, Jogging, 1Cycle or
Continuous movement.
Manual Mode Display. Jogging Mode Display. 1 Cycle Mode Display. Continuous Mode Display.
MAU JOg SIg CON
Start Measuring
With the PUSH or PULL Key, Measurement can be started.
For details refer to the Movement Mode Operation described
later. Load Tests as follows can be performed.
Press Test - Tensile Strength Test - Weld Strength
Test - Peel off Test - Absorption Power Test
Resistance Power Test - Uncapping (Seal) Test -
Punching Test.